The Stop 0×7A message indicates that a page of kernel data was not found in the paging (virtual memory) file and could not be read into memory. This might be due to incompatible disk or controller drivers, firmware, or hardware.
Frequently, the cause of this error can be determined from the second parameter, the I/O status [...]
The Stop 0×79 message indicates that the hardware abstraction layer (HAL) and the kernel type for the computer do not match. This error most often occurs when ACPI firmware settings are changed. For example, you might install Windows XP on an x86-based computer with the firmware ACPI enable option enabled and later decide to disable [...]
The Stop 0×77 message indicates that a page of kernel data requested from the paging (virtual memory) file could not be found or read into memory. This Stop message can also indicate disk hardware failure, disk data corruption, or possible virus infection.
Possible Resolutions:
1. Stop 0×77 messages can be caused by bad sectors in the virtual [...]
The Stop 0×50 message indicates that requested data was not in memory. The system generates an exception error when using a reference to an invalid system memory address. Defective memory (including main memory, L2 RAM cache, video RAM) or incompatible software (including remote control and antivirus software) might cause Stop 0×50 messages.
Possible Resolutions:
1. If you [...]
The Stop 0×3F message indicates one or more of the following problems:
1. The system Page Table Entries (PTEs) are depleted or fragmented due to the system performing a large number of input/output (I/O) actions.
2. A faulty device driver is not managing memory properly.
3. An application, such as a backup program, is improperly allocating large amounts [...]
The Stop 0×2E message indicates a system memory parity error. The cause is typically failed or defective RAM (including motherboard, Level 2 cache, or video memory), incompatible or mismatched memory hardware, or when a device driver attempts to access an address in the 0×8xxxxxxx range that does not exist (does not map to a physical [...]
The Stop 0×24 message indicates that a problem occurred within Ntfs.sys, the driver file that allows the system to read and write to NTFS file system drives. A similar Stop message, 0×23, exists for the file allocation table (FAT16 or FAT32) file systems.
Possible Resolutions:
1. Malfunctioning SCSI and Advanced Technology Attachment (ATA) hardware or drivers can [...]
The Stop 0×1E message indicates that the Windows XP kernel detected an illegal or unknown processor instruction. The problems that cause Stop 0×1E messages share similarities with those that generate Stop 0xA errors in that they can be due to invalid memory and access violations. This default Windows XP error handler typically intercepts these problems [...]
The Stop 0xA message indicates that a kernel-mode process or driver attempted to access a memory location to which it did not have permission, or at a kernel interrupt request level (IRQL) that was too high. A kernel-mode process can access only other processes that have an IRQL lower than, or equal to, its own. [...]
Microsoft claims, “With Windows XP, ClearType delivers improved font display resolution over traditional anti-aliasing. It improves readability on color LCD monitors with a digital interface, such as those in laptops and high-quality flat desktop displays. Readability on CRT screens can also be somewhat improved.”
Follow these steps to enable ClearType for Windows XP:
1. Right click on [...]
